Levelone KVM-0410 Manual de usuario

Table of Contents Introduction Overview 1 Features 1 Configurations 2 Installation Cables 5 Device Connection

LevelOne 17 next computer in sequence. The length of the Auto Scan interval (Scan Rate) is adjustable. To abort the Auto Scan mode, press t

LevelOne 19 -------------------- Cascade Configuration Connection Before connecting a device (a computer or a Slave KVM Switch) to a KVM Swit

LevelOne 21 plus 8 more computers directly connect to the Master (to "PC A"~”PC H”), see figure 13. Figure 13: All 16-port KVM Swit

LevelOne 23 --------------- Sun/Mac Keyboard Mapping For USB-PS/2 Combo models The USB-PS/2 Combo models emulate a Sun’s keyboard and mouse

LevelOne 25 ------------------------ Appendices Specifications: PS/2-only models PS/2 only models Specifications KVM-0410 KVM-0810 KVM-16

LevelOne 27 Troubleshooting: Ensure that all cables are well seated. Check that keyboard/mouse cables are not swapped. Label and bundle the

From PS/2 keyboard Map to Sun keyboard right - Ctrl 1 right - Ctrl 2 right - Ctrl 3 right - Ctrl 4 right - Ctrl F1

Limited Warranty IN NO EVENT SHALL THE DIRECT VENDOR'S LIABILITY FOR DIRECT OR INDIRECT, SPECIAL, INCIDENTIAL OR CONSEQUENTIAL DAMAGES,

LevelOne 1 ------------------------ Introduction Overview The slim LevelOne KVM Switches offer the most reliable and efficient way of managing mult

LevelOne 3 Cascaded KVM Switch (Master/Slave) Configuration A second level of Slave KVM Switches may connect to the Master unit to expand system cap

LevelOne 5 ------------------------ Installation Make sure all computers and LevelOne KVM Switches are powered down during installation. Cables Us

LevelOne 7 Figure 6: Computer USB Port Connection Initial Power-Up You must power up the Master KVM switch that has a PS/2 keyboard, mouse and mo

LevelOne 9 ------------------------ Operation Figure 7: Front pushbuttons and LEDs Pushbuttons A computer may be selected by pressing the push

LevelOne 11 port numbers, names and status, see figure 8. The port number of the currently selected computer is displayed in red, same as the front

LevelOne 13 <ENTER>. Available options will be shown in the middle of the screen. Again, using the <UP> and <DOWN> arrow keys to

LevelOne 15 non-volatile memory stores the CH Display setting. ! Position The position of the selected computer and/or OSD status displays on scree