LevelOne WAP-6103 Manual de usuario descargar pdf (Pagina 55)

CHAPTOR 4 Troubleshooting

This Chapter provides solutions to problems for the installation and operation of the WiFi

Concurrent 300Mbps Business AP. You can refer to the following if you are having

problems.

1 Why can‟t I configure the device even the cable is plugged

and the LED is lit?

Do a Ping test to make sure that the WiFi

Access Point is responding.

Go to Start > Run.

1. Type cmd.

2. Press OK.

3. Type ipconfig to get the IP of default gateway.

4. Type “ping 192.168.1.1”. Assure that you ping the correct IP Address

assigned to the WiFi Concurrent 300Mbps Business AP. It will show four

replies if you ping correctly.

Ensure that your Ethernet Adapter is working, and that all network drivers are installed

properly. Network adapter names will vary depending on your specific adapter. The

Note: It is recommended that you

use an Ethernet connection to

configure it

1 2 ... 50 51 52 53 54 55 56 57 58 59 60 ... 70 71

Sin comentarios

LevelOne WAP-6103 Manual de usuario Pagina 55