LevelOne DSA-1000 Manual de usuario

LevelOne DSA-1000 / PRT-1000 Device Server / Thermal Printer User Manual V1.0

- 10 - 3. Hardware Setup The following diagram illustrates how to connect DSA

- 11 - Note: If you are unable to get a reply from pinging DSA-1000, please

- 12 - 4. System Configuration DSA-1000 is designed specifically to operate i

- 13 - Step2: Attach DSA-1000 to a power supply using the adapter provided in

- 14 - 4.2 Gateway/Controller Configuration procedures are similar on all

- 15 - Step2: Enter the configuration page of the Service Zone which DSA-1000

- 16 - Step4: Edit and enable desired billing plans.

- 17 - 5. Operation Instructions After completing the Hardware Setup and the

Appendix A. DSA-1000 Web Interface Summary The attribute setting in this web interface is for COM 1 only. COM 2 uses default settings that are unchan-

Appendix E - Command Line Interface 19 Network Settings Static IP Ad-dress The static IP address assigned to DSA-1000. Static Subnet Mask The subnet

TABLE OF CONTENTS 1. INTRODUCTION ...

Appendix E - Command Line Interface 20 Appendix B. Firmware Upgrade Software tools tftpd32 is required in the upgrade procedure, please download and

Appendix E - Command Line Interface 21 Step4: Click Apply of Firmware Upgrade in DSA-1000’s web interface. DSA-1000 will automatically res-tart and

- 3 - 1. Introduction Overview of Network Ticket Generator Whether you are “o

- 4 - Below are two network diagrams examples using Network Ticket Generator

- 5 - WHG-1000 DSA-1000 DSA-1000 RS232 Cable RS232 Cable Ethernet

- 6 - Application Diagram Though DSA-1000 is specifically designed to for on

- 7 - 2. Device Overview Panel Overview Top Panel Adapter Socket (12V/1A)

- 8 - Bottom Panel COM 1 Serial Port for connection with a Thermal Printer. CO

- 9 - For switching the output to COM1 or COM2. Press this button followed b