LevelOne GVT-2001 Guía de instalación

Copper to Fiber Stand-Alone Media Converter Quick Installation Guide Model No. Description FVT-2001 10/100BASE-TX to 100BASE-FX MMF SC Convert

8 Link Lost Forwarding: When LLF is enable, allow UTP link failures to be reported to the fiber side and also allow Fiber link failure to be report

9 3. Cabling Fast Ethernet Module  Twisted-pair segment can be use unshielded twisted pair (UTP) or shielded twisted pair (STP) cabling. The cable

10 Optical Fiber Module Name Wavelength Avg. Launch Power Avg. Sensitivity 100Base-FX Fiber SC MM 1310 (nm) >-21dBm -31dBm 100Base-FX Fiber ST

11 4. Specification Fast Ethernet Module Standard IEEE802.3 10BASE-T IEEE802.3u 100BASE-TX/100BASE-FX IEEE802.3x Flow Control and Back pressure Con

12 Gigabit Ethernet Module Standard IEEE802.3 10BASE-T IEEE802.3u 100BASE-TX/100BASE-FX IEEE 802.3ab 1000BaseT IEEE 802.3z 1000BaseSX/LX standards I

13 5. Optional SFP Modules CVH-2000 supports 3.3V mini-GBIC module Model No. Description GVT-0300 1.25G MMF SFP Transceiver, 550 m, 850nm GVT-030

Table of Contents 1. INTRODUCTION ... 1 1.1. FEATURES ...

1 1. Introduction LevelOne media converters are Fast Ethernet 100Base-TX to 100Base-FX and 1000Base-T to 1000Base-SX/LX converters to provide the fl

2 Gigabit Ethernet Module  Comply with IEEE 802.3, 802.3u, and 802.3x, IEEE 802.3ab, 1000BaseT, 802.3z, 1000BaseSX/LX standards  Convert between

3 2. Hardware Description 2.1. Front Panel FVT-2001 / FVT-2002 / FVT-2201 / FVT-2401 GVT-2000 GVT-2001 (1) RJ-45 Port (3) Fiber/SFP Co

4 2.2. Rear Panel Power Adapter: (10/100M DC 5V, 1A; 10/100/1000M DC 5V, 2A) The rear panel contains a power socket. This power socket accepts

5 2.3. LED Indicators Fast Ethernet Module LED Status Meaning PWR On Power on FX 100 On 100Mbps Fiber Speed TX 100 On 100Mbps UTP Speed OFF 10 Mbps

6 Gigabit Ethernet Module LED Status Meaning PWR On Power on 1000 On 1000Mbps UTP Speed 100 On 100Mbps UTP Speed FDX On Converter works in the full

7 2.4. DIP-switch The DIP-switch is used to configure operation mode for LLF (Link Lost Forwarding) and operation mode for UTP/Fiber port. The defau